C-tech-i Zampina Kithen sinks Manuel d'utilisateur télécharger pdf

A= 2cm or 3cm material.

B= Caulking.

C= C-TECH-I sink.

D= Mounting clip.

Before you begin:

1. Verify that the hole is cut showing the desired overhang.

2. You will need glue and caulking to install this sink.

3. Make sure to inspect the sink and verify you have the right clips for the job.

Instructions:

1. Clean the bottom of the slab where the anchor bolt will go as to be free of any debris whatsover.

Surface must be dry and clean, it should also be rough so that the glue may bond well.

2. Position the sink in its desired location and mark it on the bottom, also mark the locations of all

anchors now (as suggested above). Depending on site conditions the amount and position of clips may vary.

You can install the anchors either face up or face down, face down is the easiest and fastest.

3. Mix enough glue for all clips, place a dab on the intended location and place the anchor on top of the glue, flatten

the excess glue flush with the the anchor plate, the plate should have about 1/16'' of glue on it. Let dry accordingly.

5. Place a small bead of caulking between the sink and the surface.

6. Install the sink in its desired location. insert clip into anchor, then the washer then the butterfly nut, tighten gently.

If the clip does not sit on the sink and surface properly you will need to bend it as shown on 2, so it may tighten.

7. Once you are content with the position of the sink tighten clips as needed.

8. Install self adhesive sound pads on each side of the bowls.

8. In an effort to minimize accidental future damages to the bottom of the sink by the homeowner please recommend

bottom strainer-grids.

You are done

Thank you for choosing a C-TECH-I product,if you have further questions please contact your dealer.

1= Anchor bolt.

2= Clip.

3= Washer.

4= Butterfly nut.

FOLLOW ALL LOCAL BUILDING AND SAFETY CODES IN YOUR AREA.

THE ABOVE IS ONLY A SUGGESTED METHOD TO BE PERFORMED

AT YOUR OWN RISK. REFER TO OSHA FOR PROPER SAFETY PRACTICES.

C-TECH-I UNDER-MOUNT FASTENING DETAIL

1 2 3

Résumé du contenu

Page 1 - D= Mounting clip

ABCDA= 2cm or 3cm material.B= Caulking.C= C-TECH-I sink.D= Mounting clip.Before you begin:1. Verify that the hole is cut showing the desired overhang.

Page 2 - E= Sink clip

ABDCEC-TECH-I DROP-IN FASTENING DETAIL A= 2cm or 3cm material.B= C-TECH-I sink.C= Screw.D= Mounting clip.E= Sink clip.Before you begin:1. Verify that

Page 3

ABDCEC-TECH-I FLUSH-MOUNT FASTENING DETAIL A= 2cm or 3cm material.B= C-TECH-I sink.C= Screw.D= Mounting clip.E= Sink clip.Before you begin:1. Verify t

Commentaires sur ces manuels

Pas de commentaire

C-tech-i Zampina Kithen sinks Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la maison C-tech-i Zampina Kithen sinks. C-TECH-I Zampina Kithen sinks User Manual [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison C-tech-i Zampina Kithen sinks